J
Joanie
I was doing a windows 2k repair from install CD (as a result to dead
motherboard replacement) and everything thing seemed to be going great
- got past the first reboot and windows was still in stage of finding
new drivers/files (I think). Anyway, it appeared to be stuck after 30
mins or so with no progess, so I rebooted, hoping it would pick up
where it stopped. Now I can't boot into windows and when I try to run
repair again from CD, it tells me its already doing the repair (can't
remember the exact message).
My question is, how can I make the repair process start over from the
beginning or pickup where it left off?
Thanks,
Joanie
motherboard replacement) and everything thing seemed to be going great
- got past the first reboot and windows was still in stage of finding
new drivers/files (I think). Anyway, it appeared to be stuck after 30
mins or so with no progess, so I rebooted, hoping it would pick up
where it stopped. Now I can't boot into windows and when I try to run
repair again from CD, it tells me its already doing the repair (can't
remember the exact message).
My question is, how can I make the repair process start over from the
beginning or pickup where it left off?
Thanks,
Joanie