R
Raymond Nichols
I recently performed a repair install of my Windows XP Pro SP-2
installation. I used my original Windows XP Pro SP-1 disk, full version.
When complete I then proceeded to reinstall the SP-2 update since it was now
back to SP-1. After two was thirds was completed a message displayed
stating Installation Failed. There were no other messages. It then
returned the system back to SP-1.
I did not remove SP-2 from the add/remove programs prior to attempting the
reinstall of SP-2 if that may matter.
Any ideas?
installation. I used my original Windows XP Pro SP-1 disk, full version.
When complete I then proceeded to reinstall the SP-2 update since it was now
back to SP-1. After two was thirds was completed a message displayed
stating Installation Failed. There were no other messages. It then
returned the system back to SP-1.
I did not remove SP-2 from the add/remove programs prior to attempting the
reinstall of SP-2 if that may matter.
Any ideas?