RAS Dial-In Support

[FrankDaCosta]

I'm using Target Designer to craft an image for a Wyse
9455XL thin client. I need to be able to RAS-dial into the
box. I've added the components that make sense (Dial-Up
Server, Dial-up Networking Common, some others). But the
RRAS service still refuses to come up; some ill-documented
dependency, no doubt.

Has *anyone* been able to make XPe listen for and accept
RAS calls?

Thanks!
Frank DaCosta

 

[Richard]

if i remember correctly, try changing Visibility to 200 and make sure u have
these components:
internet protocol network address translation
internet authentication service & remote access common files
network routing

the best way is to run Event Viewer to check what errors u get while trying
to start the service which should give u clues to files u can do filter
search for or related services

 

[Frank DaCosta]

Thanks, Richard. I read the same information on this
newsgroup, and I had already done exactly that, with no
success. I will check the Event Viewer to see if it gives
me a clue.

If Microsoft is listening: Hey, guys, do *you* know what
components I should be including? Here's what I've got:

- Internet Protocol NAT
- IAS and Remote Access Common Files
- Network Routing
- Dial-Up Server
- Dial-Up Networking Common Libraries
- Dial-Up Client
- Connection Manager Runtime
- Phone & Modem Control Panel
- TAPI User Interface

The connection wizard lets me try to setup the PC to
receive incoming calls, but hangs because the RRAS service
refuses to run.

Frank DaCosta

 

[Richard]

other components you could try..
Remote Access Monitory
IP Router Monitor Library