G
Guest
I am having a problem getting an image to boot off of USB using m-systems
udoc. I was able to get an image to work on the same system using a CF
connected to an IDE port but not using the USB udoc.
I added the udoc component and all the usb boot 2.0 components in the image
and copied it to a udoc device. I formatted the udoc device using the
formatting utility I downloaded from the m-systems site. But when I tried to
boot the system, only a blinking cursor shows. I thought it's just slow to
load but letting it run for 4 hours still shows the same cursor after the
bios. The bios is set to boot using USB.
I appreciate any suggestion I get.
thanks,
Evelyn
udoc. I was able to get an image to work on the same system using a CF
connected to an IDE port but not using the USB udoc.
I added the udoc component and all the usb boot 2.0 components in the image
and copied it to a udoc device. I formatted the udoc device using the
formatting utility I downloaded from the m-systems site. But when I tried to
boot the system, only a blinking cursor shows. I thought it's just slow to
load but letting it run for 4 hours still shows the same cursor after the
bios. The bios is set to boot using USB.
I appreciate any suggestion I get.
thanks,
Evelyn