pc bay install problem - help!!!!

[Dilbert Firestorm]

hey all..

I installed a SIIG 4 port USB bay hub in the pc's 3.5 internal device bay.
problem. the hub is not very well secured in the bay. it slides back
inside the pc if I push in a usb connector in.

and due to the way its designed, only 2 (rear of the bay) of the 4
screws can be used.

any suggestions on how to fix this?

thanx all

 

[Mike T.]

hey all..

I installed a SIIG 4 port USB bay hub in the pc's 3.5 internal device bay.
problem. the hub is not very well secured in the bay. it slides back
inside the pc if I push in a usb connector in.

and due to the way its designed, only 2 (rear of the bay) of the 4 screws
can be used.

any suggestions on how to fix this?

thanx all

You could drill holes to add two more screws. The internal wires should be
far enough from the sides that you can drill it safely. Or, you can get
some long plastic straps and feed them through the sides of the drive bay
and around the back of the USB hub to support it. -Dave

 

[JAD]

silicone, little dab will do ya

 

[Dilbert Firestorm]

where do I put this silicone on at? the screw holes?

 

[JAD]

between the side plates or on top or bottom where ever there is a small gap

 

[Dilbert Firestorm]

btw, are you talking about silicone glue?

between the side plates or on top or bottom where ever there is a small gap

 

[JAD]

btw, are you talking about silicone glue?

yeah anything like caulk for the tub,,,as this can easily be removed, if
need be.