Netgear ME102 Wireless AP

[CK]

Anyone got one of these at all. Bought one butmy wireless card cant see it
at all. Netgear reckon you need to install the USB drivers then configure it
but they dont work.

Any ideas

 

[RBM]

What do you have the AP connected to and how is it configured

 

[WebWalker]

AP is connected to a hub that is then connected to my PC.
As for config I dont have a clue as I cant access it at all. I can however
ping it on 192.168.0.5 but cant telnet or get to it via http either

Then you don't need to install the USB driver.
Open your Internet browser any key in "http://192.168.100.1" to the
address bar to configurate the router.

 

[Chris Kilian]

AP is connected to a hub that is then connected to my PC.
As for config I dont have a clue as I cant access it at all. I can however
ping it on 192.168.0.5 but cant telnet or get to it via http either

 

[CK]

I will try that later tonight when I get home and let you know how I get on

 

[Chris Kilian]

No luck
See below results
C:\Documents and Settings\chris>ping 192.168.100.1

Pinging 192.168.100.1 with 32 bytes of data:

Request timed out.
Request timed out.
Request timed out.
Request timed out.

Ping statistics for 192.168.100.1:
Packets: Sent = 4, Received = 0, Lost = 4 (100% loss)
C:\Documents and Settings\chris>ping 192.168.0.5

Pinging 192.168.0.5 with 32 bytes of data:

Reply from 192.168.0.5: bytes=32 time<10ms TTL=64
Reply from 192.168.0.5: bytes=32 time<10ms TTL=64
Reply from 192.168.0.5: bytes=32 time<10ms TTL=64
Reply from 192.168.0.5: bytes=32 time<10ms TTL=64

Ping statistics for 192.168.0.5:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

However I cant get anything via a website or telnet on 192.168.0.5

Any more ideas?

 

[WebWalker]

Check the manual, you need to know how to configurate the router/AP.

 

[CK]

Ok got a new development on this matter, I have managed to get the drivers
installed and got it working for a few minutes, then got told by the device
that it needed a new firmware which the supplier kindly supplied when I
bought it. Problem it however I ran the firmware upgrade process using the
suggested method but it died about 25% of the way through. And now I cant
see anything at all. If I try and upgrade the firmware now it just gets 5%
of the way thorough and comes up saying DFU Failed and thats it it just
closes.

Anyone know how to resolve this issue at all?