S
Spaxa
Hello everybody,
i am just trying to get a Samba share up and running on my MSDN Vista
Installation and i´ve got some problems getting it running.
Therefore i want to forward a few ports from my samba-server to my vista
machine with putty/plink over a loopback adapter
on my winXP machine everything works fine:
WinXP-->Loopbackadapter --> static ip --> Netbios deactivated --> putty
forwarding of ports 139 and 445 --> net use share ... and mapping the drive
is no problem
No as i tried this under vista i have some strange problems.
I installed the loopback device and made the following adjustments in the
properties area:
- only ipv4 and ms networking is activated
- static ip 10.0.0.1
- subnet 255.255.255.0
- no gateway
- netbios (wins) deaktivated
- routing ports 139 and 445 to my local machine the same way as i do on my
winxp machine
My general Problem is...
Access to shares on server is not available becaus i can´t find the ip
I tried everything... but i cant find a working sollution ...
Perhaps it is a problem with the Vista Networking-Center ... there my
loopback-device or loopback network is always shown as "unidentified Network"
and the "fileshareing" options are always set to "off"
Anyone else out there with the same problem ???
i am just trying to get a Samba share up and running on my MSDN Vista
Installation and i´ve got some problems getting it running.
Therefore i want to forward a few ports from my samba-server to my vista
machine with putty/plink over a loopback adapter
on my winXP machine everything works fine:
WinXP-->Loopbackadapter --> static ip --> Netbios deactivated --> putty
forwarding of ports 139 and 445 --> net use share ... and mapping the drive
is no problem
No as i tried this under vista i have some strange problems.
I installed the loopback device and made the following adjustments in the
properties area:
- only ipv4 and ms networking is activated
- static ip 10.0.0.1
- subnet 255.255.255.0
- no gateway
- netbios (wins) deaktivated
- routing ports 139 and 445 to my local machine the same way as i do on my
winxp machine
My general Problem is...
Access to shares on server is not available becaus i can´t find the ip
I tried everything... but i cant find a working sollution ...
Perhaps it is a problem with the Vista Networking-Center ... there my
loopback-device or loopback network is always shown as "unidentified Network"
and the "fileshareing" options are always set to "off"
Anyone else out there with the same problem ???