Issue with getting small network going...

[Doom59]

I posted this before but I dont think Ill get more posts
since its already pages away. Here is the posting as of
now, and thanks, sorry for reposting it but I wasnt sure
why it didnt go to the top after new posts came along:


OK, thank you very much for your help here, looks like I
will get the problem solved, but Im stuck at this line:
Select use DHCP on this page now, click ok
Where is this option? Here is what I see under TCP/IP
and under the advanced tab, where it says DHCP is
enabled. At this point, it still has the IP address
conflict that wont allow me to turn on ICS.
http://img26.photobucket.com/albums/v78/Stunna7516/error.j
pg

-----Original Message-----
Easy one this fortunatly, it looks like your network

card that works (lan) has allready go the addres
192.168.0.1 manually assigned to it, however ICS NEEDS
this address to configure itself. Easiest way to solve
this is to change the ip address of the Lan car to
something else. However if the lan card also needs this
address then you can......

view the tcp properties for the lan card (lan /

properties / tcpip) and make a note of them so you can
use them later.

Select use DHCP on this page now, click ok

now enable ICS by going properties / advanced / share my

connection / select the wifi card for the lan adapter,
click ok

ICS will now be installed on that card, go properties,

tcpip for the wifi card, notice how it's setup for
192.168.0.1/255.255.255.0, change this to
192.168.1.1/255.255.255.0 OK out

Slect the lan card and reset the settings.

Now on the computer you want to use the shared

connection with goto the wifi cards properties/tcpip, and
setup it up manually for ip 192.168.1.2/255.255.255.0
with default gateway of 192.168.1.1 and dhcp address of
192.168.1.1 and it should work.

Hope that helps

Ashleigh

sharing enabled, using the wireless connection to the
internet to connect another computer with the lan port.enabled, I run the home and small office network setup
wizard in XP. Everything is fine until the last screen,
and this pops up where it should say success:

http://img26.photobucket.com/albums/v78/Stunna7516/cannotc
omplete.jpg

right clicking my wireless connection and turning on ics
under advanced. This is the error I get:

http://img26.photobucket.com/albums/v78/Stunna7516/network
connections.jpg

my internet connection, probably because it thinks it
should be coming from the lan or maybe something else.card and lan, or figure out why Im getting these two
errors?

.

..

 

[Doom59]

Here is the status of my router:

# IP Address Device Name
1 192.168.0.2 WAVEMASTER
2 192.168.0.3 VALUED-ECECF7F4
3 192.168.0.4 SONY-VAIO

Those are the 3 computers on my network. WAVEMASTER is
the one Im on. I have my admin software set to make the
router's IP address 192.168.0.52, and the assigned IP
addresses to be 192.168.0.(2-51)

Therefore, the only thing that could be getting the IP
address 192.168.0.1 is my LAN, considering that the LAN
cards on the other computers are disabled. Any ideas?

-----Original Message-----
Hi it looks like one of your other PC's as an IP address

of 192.168.0.1 which is the IP adress for ICS you will
need to find out which one it is then change it to
something like 192.168.0.3