G
Guest
I have tried just about everything possible to upgrade from WIN98SE to Winxp
Pro on an older computer for use as a training desktop for network
administration. I recently replaced the original hard drive with a 20G IBM
Deskstar 60GXP. The drive accepted a clean install of WIN98SE and runs fine,
but for reasons that seem unique to this drive, the Desktar seems to come up
with a device inaccessible error open startup of the WinXP pro setup. I've
tried floppy boots, scandisk, fdisk.. Nothing seems to work. Is this a lost
cause, and should I just replace the drive with a less faulty brand?? I've
read numerous threads on this topic, and it seems to happen with Win2k and
just about anything past Win98SE with the IBM drives. The Hitachi website
which supports the drive offers no type of drivers or anything that can fix
the BIOS settings for installation, and simply states "drivers aren't
required for hard drives." on the support site. You'd think they would
address the common problems with all those STOP errors, but not on the site.
This computer is a 1999 Inteva, which has no customer support as the
manufacturer went out of business and its website is dead. The only bit of
hope I have is that the drive runs Win98SE flawlessly. I know this is old
news to everybody, but I just need to find a solution before replacing the
drive
Pro on an older computer for use as a training desktop for network
administration. I recently replaced the original hard drive with a 20G IBM
Deskstar 60GXP. The drive accepted a clean install of WIN98SE and runs fine,
but for reasons that seem unique to this drive, the Desktar seems to come up
with a device inaccessible error open startup of the WinXP pro setup. I've
tried floppy boots, scandisk, fdisk.. Nothing seems to work. Is this a lost
cause, and should I just replace the drive with a less faulty brand?? I've
read numerous threads on this topic, and it seems to happen with Win2k and
just about anything past Win98SE with the IBM drives. The Hitachi website
which supports the drive offers no type of drivers or anything that can fix
the BIOS settings for installation, and simply states "drivers aren't
required for hard drives." on the support site. You'd think they would
address the common problems with all those STOP errors, but not on the site.
This computer is a 1999 Inteva, which has no customer support as the
manufacturer went out of business and its website is dead. The only bit of
hope I have is that the drive runs Win98SE flawlessly. I know this is old
news to everybody, but I just need to find a solution before replacing the
drive