How do I hook up the Lights and sensors on an ATRIX tower?

Hiya mate each of the connections in the tower should be marked

PWR LED = Power Light
HDD LED = Hard drive light

etc.

IN your manual for the Motherboard it will have a diagram of all the pin and the + and - for those pins to help you connect the jumpers onto the board.

If you have extra LEDS and whatnot they usually connect to a normal Power connector on the PSU

Let us know how you get on
 
Thanks. It was a Molex cable. Now I need to figure out how to do the sensors. The instructions on the Case are not clear at all...There are two 4 pin fan1 and fan2 cable that is supposed to give me fan speeds, but I am not sure where to hook these up - do they go to the Fan Chasis?
 
Last edited:

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

hooking up the fans for the LED display? Help pls. 6
New Gaming Machine - Questions 2
I swapped my CPU, how do I carry over all my programs and settings? 1
CORSAIR Obsidian 250, the ITX case Has Both Texture and Scalability 4
Lian Li PC 100 “The Hammer” 0
Do I need to use a Web Service to hook up An Access Front End to SQLServer? 3
Best Athlon MoBo for Full Sized Tower with Temperature Sensor and Case 10
How do I hook up my Xbox 360? 1

Back
Top