R
Robert Mark Bram
Hi All!
I have posted this problem before and not received a
response - but the problem continues despite my best
efforts... and thus I go fishing again..
I have a P3 Epox motherboard and recently installed a
Seagate Barracuda 80 GB hard drive (7200.7 - ST380011A).
My motherboard doesn't recognise the drive at 80GB so I
had to change the jumpers to limit the drive to 32GB (as
Primary Slave).
I then partitioned the drive into a FAT32 partition for
data files and an EXT3 partition for RedHat Linux. I have
WinXP Pro on another drive - Primary Master.
My problem is that the drive isn't 'remounted' on boot -
I have to go to the hardware wizard to get XP to re-
detect the drive.
How might I correct this?
Thanks for any advice!
Rob
I have posted this problem before and not received a
response - but the problem continues despite my best
efforts... and thus I go fishing again..
I have a P3 Epox motherboard and recently installed a
Seagate Barracuda 80 GB hard drive (7200.7 - ST380011A).
My motherboard doesn't recognise the drive at 80GB so I
had to change the jumpers to limit the drive to 32GB (as
Primary Slave).
I then partitioned the drive into a FAT32 partition for
data files and an EXT3 partition for RedHat Linux. I have
WinXP Pro on another drive - Primary Master.
My problem is that the drive isn't 'remounted' on boot -
I have to go to the hardware wizard to get XP to re-
detect the drive.
How might I correct this?
Thanks for any advice!
Rob