Dial up components

[Leonid]

I found the problem that I can't dial up and receive incoming calls on
my image.
The external USB modem was installed successfully. I can see it in
device manager, I'm able to perform diagnostics query. All are OK. But
when I go to "New connection wizard"\Setup advanced connection\Accept
incoming connections\The list of Devices for incoming connections is
empty. There are no devices, even the modem is installed. What is
wrong in my image? What components are missed?

 

[KM]

Leonid,

And you have included RAS/RRAS stuff in your image? ("Dial-up Client for Windows", etc.)

 

[Leonid]

Hi, Konstantin
Yes, I have included the part of this stuff.
Could you point me to full stuff list?
\Leonid

 

[KM]

Leonid,

Sorry, I don't have the list. And it does not make sense to send you the lists of components of my builds that support RAS (too big
lists).

However, make sure you got these components in your build (at least for testing purposes):

-RAS
"Dial-up Client for Windows"
"Dial-Up Networking Common Libraries"
"Primitive: Rasman"
"Remote Access Monitory"
"IP Router Monitor Library"

-RRAS
"Dial-up Server for Windows" (better use hotfix Q318138)
"Internet Protocol Network Address Translation"
"Internet Authentication Service (IAS) and Remote Access Common Files
"Network Routing"
"Routing Common Files"
"Routing Table Library"
"Connection Manager Runtime"
"Phone & Modem Control Panel"
"Primitive: Tapi32"
"TAPI User Interface"

And resolve these components' dependencies.

Also add
"RAS Async adapter"
"WAN Miniport"
"Primitive: Mpr"

Again, not all of the components are necessary for you but you can give it a shot and then remove unnecessary stuff.

 

[Leonid]

Thanks
I'l try it tomorrow
\Leonid

Leonid,

Sorry, I don't have the list. And it does not make sense to send you the

lists of components of my builds that support RAS (too big

lists).

However, make sure you got these components in your build (at least for testing purposes):

-RAS
"Dial-up Client for Windows"
"Dial-Up Networking Common Libraries"
"Primitive: Rasman"
"Remote Access Monitory"
"IP Router Monitor Library"

-RRAS
"Dial-up Server for Windows" (better use hotfix Q318138)
"Internet Protocol Network Address Translation"
"Internet Authentication Service (IAS) and Remote Access Common Files
"Network Routing"
"Routing Common Files"
"Routing Table Library"
"Connection Manager Runtime"
"Phone & Modem Control Panel"
"Primitive: Tapi32"
"TAPI User Interface"

And resolve these components' dependencies.

Also add
"RAS Async adapter"
"WAN Miniport"
"Primitive: Mpr"

Again, not all of the components are necessary for you but you can give it

a shot and then remove unnecessary stuff.