Buy a DDR Kingston 512MB Stick or NOT

[zoxta]

I wanted to increase the memory of my PC , I have
Gigabyte GA-8IR2003 (REV.2) motherboard and a DDR333 256MB CAS2.
Stick.
So i waned to buy a Kingston 512MB Stick , but i only found in th
market a Kingston DDR400 512MB CAS3 , s
i wanted to know if it will be compatible with my PC or not since th
motherboard manual says that it only supports 2.5V DDR DIMM ? an
will the total RAM Become 768MB
Knowing that it doesnt matter with me CAS3 , 2.5 or 2 .
than

Sent via Archivaty.com

 

[www.interfacebus.com]

All DDR memory is 2.5 volt.

If you only have one 256MB stick and assuming 4 DIMM slots, what you
want is another 256M DIMM in the second bank ~ one in each bank for
dual channel operation....

 

[kony]

All DDR memory is 2.5 volt.

Not necessarily. That is the base voltage BUT some modules
are specified to require higher voltage to run stable at
their upper speed and SPD timings. Generally it is better
to avoid such modules, and most certainly better to do so if
the board doesn't have voltage adjustment options.

 

[kony]

On Sat, 19 Nov 2005 01:24:20 -0600,

I wanted to increase the memory of my PC , I have a
Gigabyte GA-8IR2003 (REV.2) motherboard and a DDR333 256MB CAS2.5
Stick.
So i waned to buy a Kingston 512MB Stick , but i only found in the
market a Kingston DDR400 512MB CAS3 , so
i wanted to know if it will be compatible with my PC or not since the
motherboard manual says that it only supports 2.5V DDR DIMM ? and
will the total RAM Become 768MB ?
Knowing that it doesnt matter with me CAS3 , 2.5 or 2 .
thanx

Yes, adding the 2nd module would result in 768MB. "Some"
boards require matched (at least same sized) modules for
dual channel operation, check your motherboard manual.

You didn't mention whether the new memory needs 2.5V or more
so we can't be certain if it's officially supported but it
will probably work fine. That is not a guarantee though,
you should run memtest86+ to check it before running the
operating system.

Please post a topic only one time, if you need to make
revisions to the post, put them in the same thread after the
original post appears on your news server.

 

[www.interfacebus.com]

Yes that's correct, I was thinking of the Data; VDDq which is 2.5v [ or
2.6v for DDR 400].

The over all Vdd is +3.3 V +/-0.3 V or
+2.5 V +/-0.2 V for DDR 200, 266, or 333,
+2.6 +/-0.1 V for DDR 400

Sorry about the misinformation