Boot from USB mass storage connected to HUB

[Nibe]

Hi,
I have a big and weird problem. I have done an image of WinXpe running from
a USB mass storage, everything works great.
Now I have to boot Xpe from the same mass storage but connected througha
USB hub 2.0.
When I start my PC, Windows XP logo appears and then a blue screen with this
written :

" A problem has been detected and windows has been shut down to prevent
damage to your computer.
If this is the first time you have seen this stop error screen, restart your
computer.
If this screen appears again, follows this steps:
Check for virus on your computer.
Remove any newly install hard drivers or hard drive controllers
Check your hard drive to make sure it is properly configured and terminated.
Run chkdsk /f to check for hard drive corruption, and then restart your
computer.

Technical information:
*** STOP:0x0000007B (0xF7966524,0xC0000034,0x00000000,0x00000000)"

Please anybody knows how to fix this problem?

thanks a lot

nibe

 

[Sean Liming \(MVP\)]

You need the driver for the USB hub to be in the image.

--
Regards,

Sean Liming
www.sjjmicro.com / www.seanliming.com
Book Author - XP Embedded Advanced, XP Embedded Supplemental Toolkit