Asus A8NSLI hangs on boot at device detection ACPI controller

  • Thread starter Thread starter abrogard
  • Start date Start date
A

abrogard

I just took delivery of a new computer with an Asus A8NSLI board,
Sapphire Radeon X800 GTO,Athlon64 3200 S939, assembled and tested.

I plugged in a keyboard and mouse (both PS2) and a monitor and switched
it on.

It report CMOS checksum error - loading defaults.

Then it went into the device detection routine and detected nearly a
screenfull and then hung on the acpi controller. The whole machine
hung. Can't do anything with it.

Switch off and switch on again and it doesn't give the checksum error
message but it always hangs on device detection in the same place.

I've got no ideas. I'll welcome any suggestions.

regards,

(e-mail address removed)
 
You must log in or register to reply here.

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

Unknown device on Asus A8N motherboard 8
XP sp2 Setup hangs during Device detection in the install process 3
ASUS mobo bios issue 4
Boot hangs at device listing 3
ASUS P5A boot failure 4
"The driver detected a controller error on \Device\CdRom1." ? 2
Win XP sp2 startup hangs in boot loop. 3
The driver detected a controller error on \Device\Harddisk2\D. 2

Back
Top