a7n8x deluxe bios 1007 error?

[micky]

Hi,

I think there is a problem with the new 1007 bios...
When i enable system and user password in the bios and the system
comes to the s-ata bios when booting, it stops booting after trying to
detect drives on the s-ata controller. until i press a key....
After i press a key it continues booting like it should normally.
This didn't happen with previous bios versions and i've got no drives
connected to the s-ata controller.

Can anyone else confirm this problem?

(I tried it only on mij 1.04 rev. of the board, not with the rev. 2.0
yet)

Micky.

 

[Derek Jones]

That's correct with 1007. If you have no drives then you can disable it
with a jumper on the motherboard.

Move the one marked SATA in the picture to the opposite position.
http://www.reseda.demon.co.uk/pics/jpr.jpg

 

[micky]

That's correct with 1007. If you have no drives then you can disable it
with a jumper on the motherboard.

Move the one marked SATA in the picture to the opposite position.
http://www.reseda.demon.co.uk/pics/jpr.jpg

Thanks Derek, i knew that but i was just wondering why it continues
booting with the previous bios versions and not with 1007.
(with updated s-ata bios)