G
Guest
Last Satuday when I turned on my computer, it would not load windows. It
gets as far as the windows screen then flashes a blue screen very quickly and
reboots. It goes to the safe mode ... screen and waits for me to choose an
option. I have tried every option and the same thing happens for all of
them. I tried running the install to repair the installation and i get the
following message:
Examining 152626 MB Disk 0 at ID 0 on Bus 0 on VIASRAID [MBR]
After about 45 minutes I get the screen to accept Microsoft terms and push
F8 to continue. After a while I get the following message:
-ARTITION1 [UNKNOWN] 99998MB (99998 MB FREE)
-ARTITION2 [UNKNOWN] 52626MB (52627 MB FREE)
I choose partition 1 and it says it is "updating 152626
After a while I then get the following message:
An error occured while setup was updating partition information on 152626.
Setup cannot continue. To quit press F3.
I also tried running the Seatools Diagnostic Quick test and it gets stuck on
the NTFS test.
I am running out of options. I think the data still exists on the HD but I
am unable to access it. I would like to get access to it long enough to copy
the important data to a new HD.
Has anyone encountered this problem and if so, can you help me recover from
it?
Thanks,
Zippy
gets as far as the windows screen then flashes a blue screen very quickly and
reboots. It goes to the safe mode ... screen and waits for me to choose an
option. I have tried every option and the same thing happens for all of
them. I tried running the install to repair the installation and i get the
following message:
Examining 152626 MB Disk 0 at ID 0 on Bus 0 on VIASRAID [MBR]
After about 45 minutes I get the screen to accept Microsoft terms and push
F8 to continue. After a while I get the following message:
-ARTITION1 [UNKNOWN] 99998MB (99998 MB FREE)
-ARTITION2 [UNKNOWN] 52626MB (52627 MB FREE)
I choose partition 1 and it says it is "updating 152626
After a while I then get the following message:
An error occured while setup was updating partition information on 152626.
Setup cannot continue. To quit press F3.
I also tried running the Seatools Diagnostic Quick test and it gets stuck on
the NTFS test.
I am running out of options. I think the data still exists on the HD but I
am unable to access it. I would like to get access to it long enough to copy
the important data to a new HD.
Has anyone encountered this problem and if so, can you help me recover from
it?
Thanks,
Zippy