N
nick
while trying to do a repair install of "XP home", all
goes well until "13" minutes left. i then get an error
message. at the top of the error message box it
says "unregmp2.exe - entry point not found" in the box it
says "The procedure entry point GetIUMS could not be
located in the dynamic link library MSDART.DLL." at this
point the repair stops.
i'm lost any ideas? tried typing messages into knowledge
base but no luck.
goes well until "13" minutes left. i then get an error
message. at the top of the error message box it
says "unregmp2.exe - entry point not found" in the box it
says "The procedure entry point GetIUMS could not be
located in the dynamic link library MSDART.DLL." at this
point the repair stops.
i'm lost any ideas? tried typing messages into knowledge
base but no luck.