"Kathy" said:
I have run the Network Setup Wizard several times and
keep getting error - Cannot Complete the Network Setup
Wizard. An error occurred during configuration of the
network on this computer. You can configure your network
mannually, or you can run the wizard again with different
settings. Knowledgebase has an article relating to this
but is incomplete -- does not contain any solutions.
Anyone encounter this before and have a solution?
There's no need to run XP's Network Setup Wizard. You can make the
same settings manually that it would make.
Here's a list of the actions that Windows XP's Network Setup Wizard
can perform. The exact list of actions for a particular computer
depends on the answers that you give to the "Select a connection
method" prompt:
Internet Connection Sharing host: Actions 1-9
(This computer connects directly to the Internet. The other computers
on my network connect to the Internet through this computer.)
Internet Connection Sharing or Broadband Router client: Actions 1-5,
10-11 (This computer connects to the Internet through another computer
on my network or through a residential gateway.)
Direct Internet connection: Actions 1-5, 10
(This computer connects to the Internet directly or through a network
hub. Other computers on my network also connect to the Internet
directly or through a hub.)
Actions:
1. Set the computer name, computer description, and workgroup name
that you specify.
2. Install these network components if they're not already present:
a. Client for Microsoft Networks
b. TCP/IP
c. File and Printer Sharing for Microsoft Networks
3. Share any printers connected to the computer.
4. Create the "Shared Documents" folder if it doesn't exist.
5. Share the "Shared Documents" folder.
6. Enable Internet Connection Sharing on the network connection
that you specify.
7. Enable the Internet Connection Firewall on the shared network
connection.
8. Create a Network Bridge if more than one local area network
connection exists.
9. Configure the local area network connection (or Network
Bridge) with IP address 192.168.0.1, subnet mask
255.255.255.0.
10. Configure the local area network connection to obtain an IP
address automatically.
11. Install software to allow the client to control the host's
Internet connection.
--
Best Wishes,
Steve Winograd, MS-MVP (Windows Networking)
Please post any reply as a follow-up message in the news group
for everyone to see. I'm sorry, but I don't answer questions
addressed directly to me in E-mail or news groups.
Microsoft Most Valuable Professional Program
http://mvp.support.microsoft.com