G
Guest
I have 4 computers on a home network (2ME's & 2XP's). After upgrading one of
the ME's to XPPro, the XP's can't see each other! I get "MSHOME (the
workgroup name) not accessible/You may not have permission..." messages. I
ran the Network Setup Wizard, created the set up disk and used it on two of
the XP computers - only to lose ground! This is a simple network using a
Linksys 5 port hub and it was working fine prior to the upgrade. Any advice!
I thought, foolishly, upgrading from ME to XP would solve networking
problems. It did - I no longer have a network!!!! HELLLPPPP!
Rick
the ME's to XPPro, the XP's can't see each other! I get "MSHOME (the
workgroup name) not accessible/You may not have permission..." messages. I
ran the Network Setup Wizard, created the set up disk and used it on two of
the XP computers - only to lose ground! This is a simple network using a
Linksys 5 port hub and it was working fine prior to the upgrade. Any advice!
I thought, foolishly, upgrading from ME to XP would solve networking
problems. It did - I no longer have a network!!!! HELLLPPPP!
Rick