You can use the Line method in the Page event of the report.
However, if you want it to repeat for each record, it would be easier to
place a Line control from the Toolbox into the Detail section, and then set
is properties (visible, left, width, ...)
Thanks Allen,
I used the tool box and it worked fine
i had been told that lines would not connect
right sometimes but they do.
Thaks a million
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.