F
FJB0623
When I open a workbook, I sometimes get the message "Unable to Read File".
Usally after three tries, I get the following message: "Error was detected in
'{file name}' but Microsoft Excel was able to open the file by making the
repairs listed below..." The repairs message says "Damage to the file was so
extensive that repairs were not possible..." The file, when opened, has no
formulas or formatting. Sometimes this is ok, but recently I had to reformat,
including formulas, a workbook with 12 worksheets. This was not fun.
Has anyone else run into this problem? What did you do?
Thanks,
Frank
To reply to this message, remove "mand" from my address. Thanks
Usally after three tries, I get the following message: "Error was detected in
'{file name}' but Microsoft Excel was able to open the file by making the
repairs listed below..." The repairs message says "Damage to the file was so
extensive that repairs were not possible..." The file, when opened, has no
formulas or formatting. Sometimes this is ok, but recently I had to reformat,
including formulas, a workbook with 12 worksheets. This was not fun.
Has anyone else run into this problem? What did you do?
Thanks,
Frank
To reply to this message, remove "mand" from my address. Thanks