Service Pack 2 Install Problem

[Guest]

I recently succesfully installed SP2 on my WinXP pro system.

However, it didnt go entirely smooth.

In the install, in XP, at the near end, the install just seemed to stop
dead. But the system was stable.

The install was in the following status...

--> Finishing Installation

--> Details
--> Performing Cleanup

I left it for ages and it was obviously stuck.

So I restarted, and it gave me and it was just like I had SP2 was installed,
the updates option came up, and then the security console appeared on login.

So im not sure what to do. SP2 works fine (so far), but if I install again
it wont finish the installation properly.

Thanks.

 

[Galen]

In Tom Brickman <[email protected]> had this to say:

My reply is at the bottom of your sent message:

I recently succesfully installed SP2 on my WinXP pro system.

However, it didnt go entirely smooth.

In the install, in XP, at the near end, the install just seemed to
stop dead. But the system was stable.

The install was in the following status...

--> Finishing Installation

--> Details
--> Performing Cleanup

I left it for ages and it was obviously stuck.

So I restarted, and it gave me and it was just like I had SP2 was
installed, the updates option came up, and then the security console
appeared on login.

So im not sure what to do. SP2 works fine (so far), but if I install
again it wont finish the installation properly.

Thanks.

Well, you know what they say about if it's not broken... Anyhow, have you
tried to install SP2 in safe mode from CD? That's the next step that I'd
take on that system if I were you. You did have your antivirus disabled and
nothing else running at the time of installation?

Galen

 

[Jupiter Jones [MVP]]

Tom;
Right click My Computer and click Properties?
Does it say "Service Pack 2" under System?
If it does and everything else is OK, SP-2 installation is fine.
Even from your description is sounds like installation was finished but the
cleanup had problems.

 

[Guest]

I think this might be the same problem as with Windows 2003 when you hardened
ther system. If you put the DTC (Distribution Transaction Coordinator) to
DISABLED it will fail.

Just want to inform that this has now been confirmed by MS that it's a
problem if you put the DTC (Distribution Transaction Coordinator) to DISABLED.

If you try to install Windows 2003 SP1 it will tell you that you have to
enable that service before installing - so apparently this is a problem.

This has been discussed earlier - just do a search in this forum for
"Performing Cleanup". Also discussed at HP ITRC Forum:
http://www4.itrc.hp.com/service/jam...ORUMS&pil=1&serStr="performing+cleanup"&pir=1



However, I don't know if you after SP1 can put it to disabled and future
patches can be successfully installed with the DTC service set to DISABLED.