Serial Communication Problem

  • Thread starter Thread starter Guest
  • Start date Start date
Hi George,

Start by trying to use 8,N,1 settings between two XPP HyperTerminal.

If you can't make even this to work then this problem is for some other hardware/software related NG.

Regards,
Slobodan
 
Slobodan, KM,

I do very much appreciate of your help.
Now everything has been cleared.
The cable was not electrically connected.
That's all.
It's all my miss not confirming this earlier.
Replacing the cable with a new one, everything went well as expected.

Thank you very much for associating with me for so long time.

Best regards,
George
 
Hi George,

I'm glad that it is working now :-)
But you lost two weeks because of one bad wire in three wire cable, ouch man :-(

Regards,
Slobodan
 
Back
Top