"Security Warning: Unsafe Expressions..blah, blah, blah"

[Guest]

Greetings...

I just installed Office 2003 and now when I launch previous versions of
Access programs I receive the following messages:

"Security Warning: Unsafe expressions are not blocked"
&
"Do you want to block unsafe expressions"

I went to the microsoft page for direction and was instructed to look at the
Jet 4.0 SP8; however, I also read that if I was running Windows XP (w/ SP2)
then it contained a later version of Jet 4.0 SP8....does this sound correct?
If so, it sounds like I'm back where I started from...

Bottom line, I'd like to be able to launch my Access programs w/o receiving
the above messages...any assistance would be greatly appreciated...

Thanks,

Steve

 

[Peter Foldes]

Since you are posting via the CDO interface copy\paste the below link into your Browsers address bar to access the proper group for you issue

news://msnews.microsoft.public.access.setupconfig

 

[Brian A.]

Click No. Once an Access db is open:
Click Tools > Macro > Security
Select the security level you wish, I suspect you want low.
Click Ok > No.

Keep in mind that without any macro security checking, if a nasty gets
through your defenses and ends up in a db you will not know.

--

Brian A. Sesko { MS MVP_Shell/User }
Conflicts start where information lacks.
http://basconotw.mvps.org/

Suggested posting do's/don'ts: http://www.dts-l.org/goodpost.htm
How to ask a question: http://support.microsoft.com/kb/555375