Ruler does not "snap to" properly

[Guest]

When I try to indent or outdent, either by dragging the icons on the ruler or
by clicking the automatic indent/outdent buttons, the ruler doesn't "snap to"
the half-inch or quarter-inch measurements. For instance, if I try to indent
half an inch, the cursor snaps to 0.48 instead.

I have ensured that the default measurement for the ruler is "inches."

I know I can press ALT while dragging, but I'd rather not have to!! Any
suggestions?

 

[garfield-n-odie [MVP]]

If the Drawing toolbar isn't already displayed, display it by
clicking on View | Toolbars | Drawing. On the Drawing toolbar,
click on Draw | Grid | Horizontal spacing: 0.125" | Vertical
spacing: 0.125" | check the "Use margins" box | Default | Yes |
OK. The 0.125" you enter in the spacing boxes will probably
change to display as 0.13", but that's okay.

 

[Guest]

Rats, rats, that didn't work! The horizontal spacing was, in fact, off... but
changing it to 0.125 doesn't correct the problem, even making it the default
and even in a new document. It still snaps to 0.48" instead of 0.5".

 

[garfield-n-odie [MVP]]

Did you tick the "Use margins" box? If you did, then try
unticking it.

 

[Guest]

That did it! "Use margins" had been ticked, and unticking it worked. Thank
you so much.