regedit

[JoeW]

I just went thru this whole login/logoff gig last
week...fortunately was able to use XP disk to boot and run
utility to fix. I am seeing this problem alot in
discussions. Have run Norton scan and found a TON of
adware/malware. The Norton site has detailed steps on how
to delete each one. Here's the catch...most will need to
have strings removed from the Registry. However, nothing
happens when I try to run regedit. No windows appear and
seems there is no way to get to the registry to clean out
all the malware strings. Any ideas or thoughts would be
helpful. Thanks.

 

[Michael Solomon \(MS-MVP Windows Shell/User\)]

Unfortunately, when removing various infected files after finding a virus or
viruses, some system files may be removed as well.

Try the following in order to restore the functionality:
The following assumes you have an actual XP CD as opposed to a restore CD or
restore partition supplied by your PC manufacturer.

Go to Start, type sfc /scannow in the run box and press enter. Note, there
is a space between sfc and the forward slash. You will be asked for your XP
CD. Be aware, upon inserting the CD the XP setup screen may appear, this is
not a part of sfc /scannow, rather it is being invoked by autorun. Simply
minimize the screen and allow sfc to continue.

If the above fails to resolve the issue, try a repair install as follows:

Be sure you are well backed up in case there is a problem from which you are
unable to recover. NOTE, while a repair install should leave your data
files intact, if something goes wrong during the repair install, you may be
forced to start over and do a clean install of XP. If you don't have your
data backed up, you would lose your data should that eventuality occur.

Assuming your system is set to boot from the CD-ROM drive, boot with the XP
CD in the drive. If it isn't or you are not sure, you need to enter the
system's BIOS. When you boot the system, the first screen usually has
instructions that if you wish to enter setup press a specific key, when you
see that, do so. Then you will have to navigate to the boot sequence, if
the CD-ROM drive is not first line, set it first in the boot sequence. Save
your settings and exit with the XP CD in the drive. The system will reboot.

Boot from the CD. If your system is set to be able to boot from the CD, it
should detect the disk and give a brief message, during the boot up, if you
wish to boot from the CD press any key.

Once you have pressed a key, setup should begin. You will see a reference
asking if you need to load special drivers and another notice that if you
wish to begin the ASR (Automatic Recovery Console) depress F2. Just let
setup run past all of that. It will continue to load files and drivers.

Then it will bring you to a screen. Eventually, you will come to a screen
with the option to (1) setup Windows or (2) Repair Windows Installation
using the Recovery console.

The first option, to setup Windows is the one you want and requires you to
press enter. When asked, press F8 to accept the end user agreement. Setup
will then search for previous versions of Windows. Upon finding your
version, it will ask if you wish to Repair your current installation or
install fresh. Press R, that will run a repair installation. From there
on, follow the screens.

 

[JoeW]

Thanks, Michael! Have run the sfc /scannow and the repair
installation. The registry editor now opens for a couple
of seconds then closes again. Won't stay open long enough
to remove the malware. I am trying a full installation but
don't have high hopes. Any other suggestions? Thanks.

 

[JoeW]

I am so sick and tired of fooling with this thing I want
to reformat and start over! How can I do that?

 

[Michael Solomon \(MS-MVP Windows Shell/User\)]

Before formatting and starting over try the following. Go to the following
link, scroll to line 275 and click "Lift Restrictions-TM, Regedit and CMD"
and see if that resolves the issue.

If not, here are the instructions for formatting:
Assuming your system is set to boot from the CD-ROM drive, boot with the XP
CD in the drive. If it isn't or you are not sure, you need to enter the
system's BIOS. When you boot the system, the first screen usually has
instructions that if you wish to enter setup press a specific key, when you
see that, do so. Then you will have to navigate to the boot sequence, if
the CD-ROM drive is not first line, set it first in the boot sequence. Save
your settings and exit with the XP CD in the drive. The system will reboot.

A few screens into the boot process, if you see the message on the boot
screen to "Press any key in order to boot from the CD," do so.

After loading drivers and files, you should be taken to a screen with
the following:

To Setup Windows XP now, press ENTER.
To Repair a Windows XP Installation using Recovery Console press R.
To Quit setup without installing Windows XP, press F3.

In your case, press ENTER.

Agree to the License agreement by pressing F8.

You will then be taken to a screen with two options.

To repair the selected Windows XP installation press R.
To continue installing a fresh copy of Windows XP without repairing,
press ESC.

This will bring you to a partition map where you
can delete, create and format partitions.
Select the drive you wish to format, delete the partition, then create a new
partition, format as desired and continue with XP installation.

 

[JoeW]

I don't see the link included here. Sorry.

-----Original Message-----
Before formatting and starting over try the following. Go to the following
link, scroll to line 275 and click "Lift Restrictions-TM, Regedit and CMD"
and see if that resolves the issue.

If not, here are the instructions for formatting:
Assuming your system is set to boot from the CD-ROM drive, boot with the XP
CD in the drive. If it isn't or you are not sure, you need to enter the
system's BIOS. When you boot the system, the first screen usually has
instructions that if you wish to enter setup press a specific key, when you
see that, do so. Then you will have to navigate to the boot sequence, if
the CD-ROM drive is not first line, set it first in the boot sequence. Save
your settings and exit with the XP CD in the drive. The system will reboot.

A few screens into the boot process, if you see the message on the boot
screen to "Press any key in order to boot from the CD," do so.

After loading drivers and files, you should be taken to a screen with
the following:

To Setup Windows XP now, press ENTER.
To Repair a Windows XP Installation using Recovery Console press R.
To Quit setup without installing Windows XP, press F3.

In your case, press ENTER.

Agree to the License agreement by pressing F8.

You will then be taken to a screen with two options.

To repair the selected Windows XP installation press R.
To continue installing a fresh copy of Windows XP without repairing,
press ESC.

This will bring you to a partition map where you
can delete, create and format partitions.
Select the drive you wish to format, delete the partition, then create a new
partition, format as desired and continue with XP installation.


--
Michael Solomon MS-MVP
Windows Shell/User
Backup is a PC User's Best Friend
DTS-L.Org: http://www.dts-l.org/




.

 

[Michael Solomon \(MS-MVP Windows Shell/User\)]

I'm sorry, forgot to include it:
http://www.kellys-korner-xp.com/xp_tweaks.htm