J
Josh
I have a ProView 17" crt. I just bought a Sceptre 19" LCD. The 9100 card
supports both, an LCD and a CRT monitor. When I hook up the lcd to the DVI
out on the card and try to start WindowsXP the system ends up going into a
loop, where it will keep restarting. It does this as long as the LCD is
hooked up to the DVI output. If I unhook the CRT and hook the LCD up to the
standard 15pin(the LCD supports both), the system starts up fine. But any
attempt with the LCD hooked up to the DVI results in a startup loop. The
force detection of tv box is unchecked in display properties, and driver for
the LCD is loaded and identified properly. The 9100 card is using the most
recent Catalyst Drivers also.
Can someone please help...................
supports both, an LCD and a CRT monitor. When I hook up the lcd to the DVI
out on the card and try to start WindowsXP the system ends up going into a
loop, where it will keep restarting. It does this as long as the LCD is
hooked up to the DVI output. If I unhook the CRT and hook the LCD up to the
standard 15pin(the LCD supports both), the system starts up fine. But any
attempt with the LCD hooked up to the DVI results in a startup loop. The
force detection of tv box is unchecked in display properties, and driver for
the LCD is loaded and identified properly. The 9100 card is using the most
recent Catalyst Drivers also.
Can someone please help...................