Protocol Error while attempting to use RD

  • Thread starter Thread starter Chuckie
  • Start date Start date
C

Chuckie

I have a RD host behind the Linksys BESFR41 router. If I connect through RD
client from within the same LAN using WAN IP or domain name, it'd work fine.
But from outside of LAN (remotely), I keep getting this error message
"Because of a protocol error detected at the client, this session will be
disconnected". I searched everywhere but couldn't find any resource to
decrypt this message.

BTW, I'd appreciate any links or resources to guide step-by-step through
setting up RD behind the Linky. I think port forwarding is set properly.
'Telnet dn_name/ip_number 3389' shows that it can reach the router.

TIA
 
This error typically occurs when the data stream is corrupted.. This
is a known issue with the certain firmware revisions of the Linksys
router. Take a look at the Linksys forum at http://www.dslreports.com
for information on the "good" firmware releases and for links on where
to download them...

Jeffrey Randow (Windows Net. & Smart Display MVP)
(e-mail address removed)

Please post all responses to the newsgroups for the benefit
of all USENET users. Messages sent via email may or may not
be answered depending on time availability....

Remote Networking Technology Support Site -
http://www.remotenetworktechnology.com
Windows XP Expert Zone - http://www.microsoft.com/windowsxp/expertzone
 
Back
Top