PLS HELP ME !!!

[mayurgharat]

hi,

I m Mayur. I have connected 2 HDD of 40 GB, 1 ASUS CDRW & 1 SONY
DVDRW in my system.

IDE 0 Pri : HDD 0 ( C:10GB -Win 98, D:10GB -Win XP, E :20GB )
IDE 0 Sec : HDD 1 ( H :20GB, I :20GB )
IDE 1 Pri : CDRW ( F
IDE 1 Sec : DVDRW ( G

My System Config is....

Processor : Intel 2.8 Ghz
RAM : 1 GB ( 512 x 2)
Motherboard : Mercury with 2 SATA Port.

Now The Problem is.....
2 days before my system was switched off due to power Failure.
after restarting my system the "I" Drive of HDD1 whos volume name was
DATA2, is showing me "New Volulme Lable" & when i am trying to open
this drive it gives following error....

"I:\ is not accessible.
The file or directory is currupted and unreadable."

so i tried to recover the data form the software called STELLAR
PHOENIX, after scanning the drive with this software it shows all the
data on my "I" Drive, but after restoring all the recovered data on
other drive, the properties of entire recovered DATA shows me 0 KB. i
dont know what 2 do pls help me, i think ther is some problem with
partion table, is there any way to recover my IMPORTANT DATA., pls
tell me.

Regards,
Mayur

 

[Steve Parry]

In

hi,

I m Mayur. I have connected 2 HDD of 40 GB, 1 ASUS CDRW & 1 SONY
DVDRW in my system.

IDE 0 Pri : HDD 0 ( C:10GB -Win 98, D:10GB -Win XP, E :20GB )
IDE 0 Sec : HDD 1 ( H :20GB, I :20GB )
IDE 1 Pri : CDRW ( F
IDE 1 Sec : DVDRW ( G

My System Config is....

Processor : Intel 2.8 Ghz
RAM : 1 GB ( 512 x 2)
Motherboard : Mercury with 2 SATA Port.

Now The Problem is.....
2 days before my system was switched off due to power Failure.
after restarting my system the "I" Drive of HDD1 whos volume name was
DATA2, is showing me "New Volulme Lable" & when i am trying to open
this drive it gives following error....

"I:\ is not accessible.
The file or directory is currupted and unreadable."

so i tried to recover the data form the software called STELLAR
PHOENIX, after scanning the drive with this software it shows all the
data on my "I" Drive, but after restoring all the recovered data on
other drive, the properties of entire recovered DATA shows me 0 KB. i
dont know what 2 do pls help me, i think ther is some problem with
partion table, is there any way to recover my IMPORTANT DATA., pls
tell me.

Regards,
Mayur

Have you tried running a chkdsk I: /f on the drive?

As you've used (unsuccessfully) some recovery software it "may" have made
things worse, however you could try calling the manufacturers helpline or
submitting a support ticket

http://www.stellarinfo.com/contact.htm