open ports in ICF before enabling it

  • Thread starter Thread starter Guest
  • Start date Start date
joker0927 said:
I need to open a specific port in ICF before I actually enable it.
Is this possible?
Click to expand...


Technically, yes.
I do this all the time.

I remote into some customers XP machine and turn on their firewall for them.
Before I click OK, I go into the settings area and chek the "Remote Desktop"
checkbox. Then, and only then, I press the Apply button. Instant firewall
on, remote desktop never misses a beat and I can still assist them when
needed.

However, I somehow doubt that is what you meant - perhaps if you give an
example of what you want to do or how you want to do it.. Is it during some
unattended installation? Is it through registry values you are wanting to
do this? What ports are you wanting to leave open? etc.
 
Actually, that is almost exactly what I want to do. The only difference is that I'm using VNC. I want to be able to open the VNC ports before enabling it so as not to kick myself out.

Thanks so much for you pompt reply. I feel a little silly knowing how simple the solution was now.
 
joker0927 said:
Actually, that is almost exactly what I want to do. The only
difference is that I'm using VNC. I want to be able to open the VNC
ports before enabling it so as not to kick myself out.

Thanks so much for you pompt reply. I feel a little silly knowing
how simple the solution was now.
Click to expand...

Ah. Okay then, glad to help.

Don't feel silly for asking.
What would the point be if you already knew everything? heh
Talk about being bored!
 
Back
Top