**NO SIGNAL DETECTED**

[Jim Morrison]

I have following problem:
When I turn my computer off, and then turn it on I get no picture on screen,
only "signal not detected", the only way to get picture back is to take my
graphic card out of MB and then put it back in and turn pc on. Of course
when I later turn it off I need to repeat all this again. Another way is to
turn pc on and off quite many times, even plug power cable out, and then
after bout one hour of doing this i get picture..
Monitor is LCD, and it works, tried on other computers, graphics card is ATI
X600XT and MB is Intel "Battle Lake" and it's all new.
I red somewhere that it could be error on MB, that it doesn't send signal
into monitor quick enough at startup...

Can someone help..? Thanx..

 

[Kent_Diego]

When I turn my computer off, and then turn it on I get no picture on

screen, only "signal not detected", the only way to get picture back is to
take my graphic card out of MB and then put it back in and turn pc on. Of
course when I later turn it off I need to repeat all this again. Another
way is to turn pc on and off quite many times, even plug power cable out,
and then after bout one hour of doing this i get picture...

I would think most likely the motherboard but a had a computer with a cold
turn on problem that was cures with a new power supply.