Networking Setup Wizzard Fails - Spooler Subsystem App problem

[Guest]

I have been trying to setup a home wireless network. My desktop is connected by wire to a Linksys-G broadband router. When I try to run the Network setup Wizzard I eventually get to the screen that say the wizzard is configuring for home or small office network- please wait. After a short time an error message pops up and the wizzard is stopped. The message states "Spoole subsystem Application has encountered a problem and needs to close

Where do I go from here?

 

[Eric Cross [MVP]]

Greetings Doug,

Try stopping the spooler service before you run the Network Wizard.

1. Open the command prompt and type:

"net stop spooler" (without quotes) and Press ENTER.

2. Then run the Network Wizard.

After you are finished, you can restart the service. Type "net start
spooler" at the command prompt.

________________
Eric Cross, MS-MVP (Windows Networking)

I have been trying to setup a home wireless network. My desktop is

connected by wire to a Linksys-G broadband router. When I try to run the
Network setup Wizzard I eventually get to the screen that say the wizzard is
configuring for home or small office network- please wait. After a short
time an error message pops up and the wizzard is stopped. The message states
"Spoole subsystem Application has encountered a problem and needs to close"