network cable unplugged

  • Thread starter Thread starter Steve
  • Start date Start date
S

Steve

Help!!!!
i put dlink dfe-530tx+in my 2 computers connected the cat
5e cable to each and i get network cable unplugged on
both computers. i went out and bought a different cable
same cat 5e and get the same results Any advise please
 
Hi Steve,

There are many things that can cause a Network Cable
Unplugged message.

1. The network cable is defective.
2. The network cable is really unplugged.
3. The cable is a wrong type.
4. The cable connected to the uplink port instead of a
regular port.
5. Some hubs, switches and other devices disable the port
next to the uplink port when it's in use. Try a different
port.
6. The network card driver program isn't working right.
Try downloading compatible drivers for the network card.
7. It's plugged in at both ends but the computer on the
other end isn't turned on.

I hope this helps.

___________________
Eric
 
If you want to DIRECTLY connect the two PCs with a
single cable, it must be a CROSS-OVER Cable!
--
Regards,
Pat Garard
Australia

Anne & Pat Garard.
apgarardATbigpondDOTnetDOTau
_______________________________________________
 
-----Original Message-----
If you want to DIRECTLY connect the two PCs with a
single cable, it must be a CROSS-OVER Cable!
--
Regards,
Pat Garard
Australia

Anne & Pat Garard.
apgarardATbigpondDOTnetDOTau
_______________________________________________

Thanks for the info. Bought 2 wrong cables would of been
Click to expand...
cheaper to buy a hub. Thanks again.
 
Well done Steve!
--
Regards,
Pat Garard
Australia

Anne & Pat Garard.
apgarardATbigpondDOTnetDOTau
_______________________________________________
 
Back
Top