Master_Slave Cable position

  • Thread starter Thread starter None Required
  • Start date Start date
N

None Required

The way my system is laid out using a replaceable HD bay for removable
storage the ribbon (80 wire) pretty much has to be set up so the Master is
in the middle position and the Slave is on the end. I did find a 40 wire
ribbon where the connection lay out worked but this is not suitable for the
HD and controllers.

It seems to boot and recognize drives OK. Is the Master/Slave position on 80
wire critical? On 40 wire it wasn't as long as the jumpers were set
properly.

Fritz
 
Position on the cable only matters if you are using the
cable select jumper settings, otherwise the master/slave
jumper controls.


message | The way my system is laid out using a replaceable HD bay
for removable
| storage the ribbon (80 wire) pretty much has to be set up
so the Master is
| in the middle position and the Slave is on the end. I did
find a 40 wire
| ribbon where the connection lay out worked but this is not
suitable for the
| HD and controllers.
|
| It seems to boot and recognize drives OK. Is the
Master/Slave position on 80
| wire critical? On 40 wire it wasn't as long as the jumpers
were set
| properly.
|
| Fritz
|
|
 
Back
Top