Margin Markers not displayed

S

Sol

I am teaching Word 2003 to a retirement community group. They have their own
computer lab. On two of the eight computers, the Margin Markers are not
visible. How can I make them visible? All the computers are in the Print
Layout View with the rulers showing.

The margin markers i am referring to are the images on the ruler. On the
left, at the margin, should be a compound marker with a rectangle, an upward
pointing triangle, and a downward pointing triangle. On the right margin
marker should be an upward pointing triangle. These are the images that do
not appear.
 
R

Rae Drysdale

Have the markers been dragged off to the left and right of the ruler? Check
the Format | Paragraph to see if there is a minus indentation.
 
S

Sol

Since I will not be on site until Thursday, I tried it on my own
installation. I could not drag the markers all the way off to cause them to
disappear. Moreover, when I dragged them as far as they would go (which was
to zero left and right margins) the shaded areas on the ruler disappeared but
not the marker. The computers in the lab did show the shaded areas.
 
S

Sol

Rae Drysdale said:
Have the markers been dragged off to the left and right of the ruler? Check
the Format | Paragraph to see if there is a minus indentation.
 
R

Rae Drysdale

Try using the menu. Format | Paragraph and insert -20 cm in the indent area.
You will still see the dark blue area, but not the markers.
 
S

Sol

When I enter -20cm, I get a message box telling me the measurement must be
between 0" and 22"
 
R

Rae Drysdale

Sorry, that should be -20 mm or if you work in inches -2 inch. Try different
minus measurements appropriate to whatever you are using.
 
S

Sol

Attempts to insert ANY negative measurement generates the message "the
measurement must be between 0 and ... ." In otherwords, a negative
measurement is not accepted.
 
R

Rae Drysdale

When you get to the computers, check the measurements on the paragraph
indentations (Format | Paragraph | Indentation) I can enter minus
measurements here without any error messages. I can't enter minus
measurements in Page Setup.
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Top