I disabled my monitor?

[Guest]

Last night I installed a tune-up program. I did 2 things - one was supposed
to correct registry. Second was I unchecked a whole bunch of stuff from
start-up. Clearly I made a mistake somewhere. After restarting my monitor
is not receiving any signal, not even thru the start-up process. I tried to
access thru go-to-my-pc but it says I am not connected.

How do I go back or undo the changes if I can't see the screen? Any help
would be greatly appreciated!

Than you,

Patrick

 

[Richard Urban]

Do you see anything on the monitor at all during the boot process -
anything?

If not either the monitor or the video card went bad. It could also be a
cable connection from the monitor.

If you DO see some early screen activity, you likely damaged your video
drivers or some such. If so, it's time to reinstall the operating system.

--


Regards,

Richard Urban
Microsoft MVP Windows Shell/User
(For email, remove the obvious from my address)

 

[John Barnes]

You may be able to do a system restore from your install DVD and get your
prior settings back.