Help, please

[Lori]

Hi,

Here is what I am trying to do. I have a master
blueprint of a building. I also have blueprints of each
unit (room) off the master blueprint. What I would like
to do is show the entire blueprint (master) on the form.
But when clicking on a certain room would like the unit
blueprint to open. Does anyone have any suggestions as
to how I may be able to do this? Also, the master
blueprint is very large and becomes distorted if shrunk
down too much. Does anyone know of an access compatible
panning software? I appreciate any suggestions. Thanks,
Lori

 

[PC Datasheet]

If your blueprint is in AutoCad, AutoCad has a panning utility.

Another way to do it is to partition your large blueprint into a multitude of
viewable areas by overlaying labels. You would then view the large blueprint and
when you click on any label you would bring up an image control that contained
the viewable area for the label.

 

[Lori]

this is how i have it set up now, just wasn't sure there
might be a better way. thanks!