G
Guest
While attempting to use FSTW (thru a direct cable connection), I continue to
have a problem at the "set up your serial connection" page. Auto detect
begins to run on both the old and new computer but the two computers cannot
detect each others serial port. Error message reads :"Wizard could not
connect to the other computer...please make sure the cable is properly
connected".
Checking the network connections page shows the two computers connected with
the cross-over cable. Is there anything I need to do to get this wizard to
work.
Thanks for your help!
have a problem at the "set up your serial connection" page. Auto detect
begins to run on both the old and new computer but the two computers cannot
detect each others serial port. Error message reads :"Wizard could not
connect to the other computer...please make sure the cable is properly
connected".
Checking the network connections page shows the two computers connected with
the cross-over cable. Is there anything I need to do to get this wizard to
work.
Thanks for your help!