W
Will from Watertown
Getting error 678 with ethersplit network.
Ok, here's what I've done so far.
Reset tcp/ip stack
reinstalled winsock.
installed brand new NIC (linksys with xp verified drivers)
Had verizon verify building wiring was good (wiring is
immaculate)
Recreated PPPoE connection mulitple times.
Notable items:
third-party PPPoE software had never been installed on
this machine.
XP pro
NIC shows solid green
In the registry, under HKLM/Services, there was
CurrentControlSet (like normal) and also Current Control
Set (not normal) I didn't expand under the Current
Control Set to see what was listed as this support was
all done telephonically, but I suspect this is going to
be linked to the issue somehow.
Any help I could get would be very much appreciated.
Ok, here's what I've done so far.
Reset tcp/ip stack
reinstalled winsock.
installed brand new NIC (linksys with xp verified drivers)
Had verizon verify building wiring was good (wiring is
immaculate)
Recreated PPPoE connection mulitple times.
Notable items:
third-party PPPoE software had never been installed on
this machine.
XP pro
NIC shows solid green
In the registry, under HKLM/Services, there was
CurrentControlSet (like normal) and also Current Control
Set (not normal) I didn't expand under the Current
Control Set to see what was listed as this support was
all done telephonically, but I suspect this is going to
be linked to the issue somehow.
Any help I could get would be very much appreciated.