enlarge a number to 1/2 page size

  • Thread starter Thread starter Guest
  • Start date Start date
G

Guest

I need to make a few numbers for a display...each needs to fit 1/2 sheet of 8
1/2" by 11" paper..THanks for any help
 
Change your font size by clicking the *number* that appears in the Font Size
list window (not by opening the list) & type the value you want to use, press
Enter. Depending on top & bottom margin settings, ~280 ought to do it.

HTH |:>)
 
Close, but not exactly... in fact, it can vary more than you may think.

The point size specifies the range that the characters must fit within,
measuring from the tallest ascender to the lowest descender in the font. It
is entirely possible (in fact, probable) that type set to 72 points will not
contain _any_ characters 1" in height. But the 72 pts = 1" conversion is
accurate :)

Regards |:>)
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

How do I increase the size or a letter or number to fill page? 2
Changing paper sizes 2
Page Numbers not in sequence 4
How do I set up a page horizontally vs vertically 2
page numbers 2
Headers & Page Numbering 1
Multiple (Different) Page Numbers On A Single Page 2
How do I print 2-pg folded booklet from reg page data? 1

Back
Top