Disable ports 135&445 for IPv6 only ?

[david.balazic]

Hi!

I run a dual stack setup.

Assumption : ports 135 and/or 445 are needed for file sharing.

I want to be able to use file sharing over IPv4 on my local net, but
want to disable the ports 135, 445 (and 1026 too, the lsass.exe port)
on IPv6. They buth run on the same interface (ethernet card).

Is this possible ?

(if the above assumption is wrong, then I will just disable these
ports for both protocols)

Thanks and regards,
David

 

[Allan]

Hi!

I run a dual stack setup.

Assumption : ports 135 and/or 445 are needed for file sharing.

I want to be able to use file sharing over IPv4 on my local net, but
want to disable the ports 135, 445 (and 1026 too, the lsass.exe port)
on IPv6. They buth run on the same interface (ethernet card).

Is this possible ?

(if the above assumption is wrong, then I will just disable these
ports for both protocols)

Hi, I suggest you cross-post this question in
microsoft.public.platformsdk.networking.ipv6 instead of asking here.