S
Shelly
Here is the situation.
I have a button and I have the click event. When it is clicked, it enters
that subroutine (submit_Click). As part of the processing it checks two
sets of fields. If either of these sets fails (no checkbox checked, for
example), then an error message control is set and no further processing is
done and the page reappears with the error message presented.
Here is the problem:
WheIf I then set one of the check boxes so that it should pass the test, and
then click the submit button nothing happens. I also did this in the
debugger, but it didn't break in the submit_Click routine as it did the
first time.
Does anyone have any suggestions?
Shelly
I have a button and I have the click event. When it is clicked, it enters
that subroutine (submit_Click). As part of the processing it checks two
sets of fields. If either of these sets fails (no checkbox checked, for
example), then an error message control is set and no further processing is
done and the page reappears with the error message presented.
Here is the problem:
WheIf I then set one of the check boxes so that it should pass the test, and
then click the submit button nothing happens. I also did this in the
debugger, but it didn't break in the submit_Click routine as it did the
first time.
Does anyone have any suggestions?
Shelly