Chart repeats in report

[JohnWhyte]

Hi,

I have form based charts and tables and reports as sub-objects
in one report, "Appendix". This takes one report
header and nine section headers, no footers or detail section used.

However, I noticed, as I built "Appendix", that a peculiar effect has
happened, which to my, ignorant eye appears to be random. The effect is that

some charts are repeated on the next page, and the following pages, for
several more pages. As they repeat they gradually change vertical height on
the Appendix report's pages. That is, the same chart (or table) repeats on
several following pages but changes height, often on the at first, next page
too tall and, then, getting progressively smaller on the following pages.

I've placed page beaks at strategic points but to no effect. But I don't
really know what's going on: Basically I'm just guessing!!

Do you know what causes this?

Thanks,

John

 

[Guest]

I had a similar problem where the one chart had many pages. What I did was
move the chart to the "header" instead of the "detail" area of the report.
Good Luck!

Devon Vinson

 

[JohnWhyte via AccessMonster.com]

Thanks, Devon.

However, none of my charts are in the detail section. They are all in the
header or footer.

John

I had a similar problem where the one chart had many pages. What I did was
move the chart to the "header" instead of the "detail" area of the report.
Good Luck!

Devon Vinson

Hi,

[quoted text clipped - 19 lines]

John