Adding two disks raid0

  • Thread starter Thread starter George
  • Start date Start date
G

George

Is it possible two add two new disks in raid0 on an existing windows vista
home premium 32 bit installation and how?

Thanks
George
 
You need to provide more info. Is this array going to be the system drive or
just data storage? If the latter I highly recommend against it, if the
former you need to have a good backup routine in place.
You can take your current Vista installation and migrate it to a stripped
array but it is not a simple task.
 
It is going to be the system disk.If I can start windows with the array as
just storage I will manage the migration.
Can you help me ?
Thanks
 
Basically, you need to enable the RAID controller and install the drivers in
Vista, then use an imaging tool to image the single drive to the array, this
usually works but you may run into problems, also you may need to change the
BIOS boot order and set the array as bootable in the RAID setup utility.
 

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.

Ask a Question

Similar Threads

RAID0 6
Low disk write performance on Promise EX8350/Raid0/Vista64 Busines 4
RAID0 question 27
Using two different capacity HD in Raid0 mode ? 3
SATA1 SATAII 1
Separate partition for swap file 2
"Injecting" RAID into a functioning Vista build 4
Installing Vista 64 1

Back
Top