2007 Access run time engine

[DougKalish]

When I tried to run a database with reports using the 2007 run time engine
on a computer that did not have Access loaded I was able to get the form on
the screen but was unable to see any reports. I am able to enter data but
there is no way to access the reports. Someone said that if I were hooked up
to a printer it would work if I used a 2003 run engine. So far I haven't
tried to run the 2007 engine with the computer hooked to a printer. Any
suggestions? It's a very simple database I have created and one would think
that the run time would allow reports to show on the screen.

 

[DougKalish]

Thanks Chris, but I tried it with a printer installed and it still doesn't
work. Any other ideas? The program was originally developed on a 2003
Access. Where can I find a 2003 run time engine?

 

[DougKalish]

Thanks Chris.... I think I discovered the problem. I didn't use the
developer's tools to create a template, auggghh! A Senior moment I guess.

 

[Larry Singleton]

Chris I am working with Doug on this problem and here is what we have done,
1. created db using access 2003
2. converted db to 2007 on new system
3. downloaded Develper ext 2007 and ran solution wizard. with runtime added.
4. took output to another system without ms access installed and tested the
install of db. everything works except we can only see one form , no reports
at all.
printer is installed. added sp1 to system with access 2007.
are we supposed to be able to use reports and queries and etc.??

 

[Larry Singleton]

Chris, everything you said was done and now it works....Thank you very much.
Larry