R
Ross
I am trying to use my XP Pro disk to do an XP Repair. Below I will detail the
steps I do and the problem I end up with:
1. Boot up with the XP disk in the cd rom
2. Go to the point where I get the option to “enter R for repairâ€
3. The PC goes into DOS mode and I get asked “which windows installation
would you like to log ontoâ€. I enter the number “1â€.
4. Then I am asked to type “Administrator Passwordâ€. I have no
administrator password so I leave the space blank and just hit enter.
5. I then get the prompt “C:\Windows>â€.
6. At this point I am stuck. Because it does not matter what I enter, I
keep getting a message that says “command not recognizedâ€.
I would really like to move past this and use the XP Repair option. All help
and suggestions appreciated.
steps I do and the problem I end up with:
1. Boot up with the XP disk in the cd rom
2. Go to the point where I get the option to “enter R for repairâ€
3. The PC goes into DOS mode and I get asked “which windows installation
would you like to log ontoâ€. I enter the number “1â€.
4. Then I am asked to type “Administrator Passwordâ€. I have no
administrator password so I leave the space blank and just hit enter.
5. I then get the prompt “C:\Windows>â€.
6. At this point I am stuck. Because it does not matter what I enter, I
keep getting a message that says “command not recognizedâ€.
I would really like to move past this and use the XP Repair option. All help
and suggestions appreciated.