which tcp ports......

[Alberto Brivio]

Dear ALL,

in order to spread win 2003 domain's machines over remote locations, what
are tcp / udp ports and protocols I have to grant access over firewall , so
that domain / active directory can run properly?


Regards

Alberto
Brivio

--


Alberto Brivio

(tel. 1 9 9 2 4 9 8 9 8)

 

[Tim Hines [MSFT]]

The following articles list the ports that you need.

AD Replication over firewalls
http://www.microsoft.com/technet/pr.../activedirectory/deploy/confeat/adrepfir.mspx

179442 How to configure a firewall for domains and trusts
http://support.microsoft.com/default.aspx?scid=kb;EN-US;179442

832017 Service overview and network port requirements for the Windows Server
system
http://support.microsoft.com/default.aspx?scid=kb;EN-US;832017



Tim Hines

 

[Paul Bergson]

Check out the port definitions I have defined in the link below. It can get
a little tricky when you start dealing with the rcp high ports and locking
them down to specific ports. The document details nt4 v 2003 trust but the
port and rpc info is what you want.


http://pbbergs.dynu.com/windows/articles.htm then select NT4 v AD Trust

Look for the section Configuring Domain Controller Ports and stop at the NT4
ports. You will want the registry frs info as well. I'm going to set up a
seperate web page using this info but just haven't had the time yet.

It will also give some info on troubleshooting with PortQryUI

--

Paul Bergson MCT, MCSE, MCSA, CNE, CNA, CCA

This posting is provided "AS IS" with no warranties, and confers no rights.