G
Guest
I have recently added a 160Gb Maxtor 6 P160PO drive in an external hi-speed
USB housing connected via a 4 port USB-2 card. I have tried copying large
amounts of data (13-20Gb) but after a few minutes, I get "The drive is not
ready" and it disappears from My Computer. If I disconnect it and re-connect
it, it will reappear. The same happended with a 20Gb drive I swapped in, so
it seems that it's not the drive. I have tried a different port to no avail.
Any ideas?
USB housing connected via a 4 port USB-2 card. I have tried copying large
amounts of data (13-20Gb) but after a few minutes, I get "The drive is not
ready" and it disappears from My Computer. If I disconnect it and re-connect
it, it will reappear. The same happended with a 20Gb drive I swapped in, so
it seems that it's not the drive. I have tried a different port to no avail.
Any ideas?