R
Rhythmwiz
I have just purchased a 160Gb Seagate Barracuda 7200.7
drive to use as my new boot drive. On installing Windows
XP, the drive works perfectly, and Device Manager shows the
transfer mode for device 1 on my primary IDE channel (the
Barracuda drive) as Ultra DMA Mode 5. Every time, however,
that I install Service Pack 1 for Windows XP, the transfer
mode switches to PIO, and performance is awful. I have
tried installing Windows and then the Service Pack at least
4 times now, and the same thing happens every time. How do
I re-enable UDMA 5 under Service Pack 1? (Selecting 'Use
DMA if available has no effect - it still stays on PIO)
Thank you very much for your time.
drive to use as my new boot drive. On installing Windows
XP, the drive works perfectly, and Device Manager shows the
transfer mode for device 1 on my primary IDE channel (the
Barracuda drive) as Ultra DMA Mode 5. Every time, however,
that I install Service Pack 1 for Windows XP, the transfer
mode switches to PIO, and performance is awful. I have
tried installing Windows and then the Service Pack at least
4 times now, and the same thing happens every time. How do
I re-enable UDMA 5 under Service Pack 1? (Selecting 'Use
DMA if available has no effect - it still stays on PIO)
Thank you very much for your time.